MECH Category

MECH-HoD International Journals

Updated on
  1. DETERMINATION OF FAILURE STRENGTH OF FLATE PLATE WELD JOINT USING FINITE ELEMENT ANALYSIS K.L.N.MURTHY at.el. International journal for innovative engineering and management research, vol 07, issue 02 page no: 462-474. (2018).
  2. FRACTURE, FATIUGE GROWTH RATE AND VIBRATION ANALYSIS OF CAM SHAFTS USED IN RAILWAYS K.L.N.MURTHY at.el. International journal for innovative engineering and management research, vol 07, issue 02 page no: 260-267. (2018).
  3. FE ANALYSIS KNUCLE JOINT USED IN TRACTOR TRAILLER K.L.N.MURTHY at.el. International journal for innovative engineering and management research, vol 07, issue 02 page no: 330-337. (2018).
  4. DESIGN AND OPTIMIZATION OF CAR WHEEL RIM FEA TECHNIQUE K.L.N.MURTHY at el. .Advanced research journal of science and technonology, volumeIV,issue I, 136(3) (2016).
  5. IMPACT ANALYSIS OF CAR BUMPER FOR VARIABLE SPEEDS BY USING E-GLASS EPOXY AND CARBON EPOXY MATERIALS K.L.N.MUERTHY at el. Advanced research journal of science and technonology, volumeIV,issue I, 137(3) (2016).
  6. DESIGN AND ANALYSI OF A FOUR WHEELER ENGINE BLOCK K.L.N.MUERTHY at el. Advanced research journal of science and technology, volume IV, issue I, 145, (2016).
  7. AGEGING RATE OF PAPER INSULATION IN TRANSFORMERS ON ITS MECHANICAL STRENGTH K.L.N.MURTHY and Dr. S. Sreendha reddy,  International Journal of Mechanical engineering, vol-2, issue-2-2014.
  8. FRP COMPOSITE LAMINATE BEHAVIOR UNDER LOW VELOCITY IMPACT LOAD K.L.N.MURTHY and Dr. S. Sreendha reddy, International Journal of Mechanical and production engineering, vol-2, issue-3-2014.
  9. REDUCTION OF SMOKE EMMISSION FROM DI DIESEEL ENGINE USING CATALYST BASED OXYGEN ENRICHMENT K.L.N.MURTHY and Dr. S.Sreendha reddy, International Journal of Mechanical and Industrial  engineering,vol-3,issue-1-2013.
  10. EXPERRIMENTAL STUDY OF TURBULENT INVERSE DIFFUSSION FLAME IN COAXIAL BURNER K.L.N.MURTHY and Dr. S.Sreendha reddy, International Journal of  Applied research in Mechanical engineering,vol-2,issue-2-2012.
  11. DEVELOPMENT OF ADVANCED WIRE CUT EDM WITH MULTI PROGRAMMING DISPLAY AND COMPUTER CONTROL MEDIUM, K.L.N.MURTHY and Dr. CH.Mallikarjuna, International Journal of  Applied research in Mechanical engineering vol-2,issue-2-2020.

You may also like...